Equipment
Forum Thread of the Day: “Talk to me about driving irons…”
Today’s Forum Thread of the Day comes from balls_deep who as a high ball hitter, has sought WRXer’s advice on what driving iron may suit him best. In balls_deep’s words, he’s looking for “something that goes straight and is easy to flight high or low when needed and doesn’t want to go left” and a club off the tee which he can use “for shorter par 4s I can knock down and run out but still use on long par 3s and second shots into par 5s around the 220-230 mark.” Our members share their suggestions.
Here are a view posts from the thread, but make sure to check out the entire discussion and have your say at the link below.
- jvincent: “I’m going to guess P790 UDI will be the best option. I’m not quite as fast as you but am looking for a similar club, low launch, low spin for off the tee. I’ve resisted pulling the trigger on a few UDIs I’ve seen on eBay. So far.”
- Lefty96: “I switched to a driving iron this year for the same reasons you’re stating about the hybrid. I would say we are very similar statistically speaking with our ball flights and speed. I added an 18 degree Srixon u85, and it does everything I need it to. I find it very easy to hit both off the tee and the fairway. It’s become a solid 230 club for me. I still launch it fairly high on a normal swing, but it is still lower than my old 18-degree hybrid. If I want to flight it low into the wind, I can make it happen the same way I would my 4 iron which is something I couldn’t do with the hybrid. It’s been a great club. I looked at the tmb but found it much less forgiving. That should be obvious when looking at the size differences, but for me, the slightly chunkier look doesn’t offend me with a driving iron.”
- Pwood28: “Since you’re already playing a T-MB in your 4 iron, assuming you like it, I’d throw in the 3 iron since height, spin and distance don’t seem to be an issue. I’d also vouch for the UDI as a good choice and throw in the new Mizuno HMB. I recently bought a HMB 3 iron, and it is large enough that it gives you all the confidence in the world to go after the ball, but still retains decent looking lines.”
- drvrwdge: “Srixon U85 at 20* for me. Its 250ish off the tee and my 235-240 club of the deck. Went Recoil 95 F5. Can flight it, hit it high, turn it over, hold it off etc.. Does everything and is supper forgiving especially on toe side strikes. Had an i500 3i with an AD 95x for a while and it was just tough to elevate off of the deck. Not as forgiving as the U85 either.”
- wam78: “I hit the u500 last week, and I came away impressed. Fantastic look at address without looking too GI. Felt good out the middle and was pretty easy to hit. If I were in the market probably would have purchased not the spot.”
Whats in the Bag
Christiaan Maas WITB 2026 (June)
Driver: TaylorMade Qi4D LS (8 degrees)
Shaft: Fujikura Ventus TR Blue 6 X

3-wood: TaylorMade Qi10 (15 degrees)
Shaft: Fujikura Ventus Black 9 TX

Irons: TaylorMade P770 (3), TaylorMade P7CB (4), TaylorMade P7TW (5-PW)
Shafts: Fujikura Ventus Black HB 10 X, True Temper Dynamic Gold X100

Wedges: TaylorMade Prototype (50-SB09), TaylorMade MG5 (56-HB12, 60-LV07)
Shafts: True Temper Dynamic Gold S400


Putter: TaylorMade TP Juno

Ball: Titleist Pro V1x
Grips: Golf Pride Tour Velvet Cord
Check out more in-hand photos of Christiaan Maas’ clubs here.
Equipment
TaylorMade MySpider Tour and Tour X: More customizable build options now available
TaylorMade Golf’s MySpider program underwent a substantial overhaul over the last month. Firstly, the company launched the option to customize the Spider ZT model, and now the program has returned with the MySpider Tour and MySpider Tour X.
The revamped page now gives golfers complete control over every visual and functional detail of their putter on the popular Tour and Tour X head, with every cosmetic idea thought of. In MySpider Tour, golfers can choose from four head finishes, 16 paint fill colors, nine Surlyn face insert colors, three aluminum insert options, six sightline configurations, and four hosel options — L-neck, small slant, double bend, center shaft. Six sightline options are available in MySpider Tour, including the optically engineered True Path alignment system. MySpider Tour X gives builders the option of four head finishes, four hosel configurations, and five sightline options, also including True Path alignment.
One of the more interesting features of the new MySpider program is the availability of three distinct face insert options. Along with the usual Surlyn Pure Roll insert trusted by Scottie Scheffler and Rory McIlroy, which can be customized from nine colors, golfers can now also select firmer options. Two are offered with the black aluminum Pure Roll insert, slightly firmer than the traditional insert, or for the firmest feel, golfers can choose from two colors of milled aluminum inserts.

Another fun addition to the MySpider Tour is the ability to use the “Tommy Sightline.” The custom alignment aid design, which was first drawn onto Tommy Fleetwood’s putter by PGA Tour Rep James Holley, is based on the milled sightline on his Spider ZT head. There are five shorter lines on the left and right of a longer central line serving as the traditional short line alignment aid.
See below for the full specifications sheet for MySpider Tour and Tour X:
MySpider Tour

MySpider Tour X

Equipment
Then and now: Comparing Rory McIlroy’s current setup to his record-breaking 2019 Canadian Open victory
In Rory McIlroy’s first appearance at the 2019 RBC Canadian Open, he crushed the record books to earn his 16th PGA Tour title in dominating fashion, winning by seven shots over Shane Lowry and Webb Simpson.
McIlroy’s score of 22-under-par 258 is the lowest 72-hole score to date at the Canadian Open, and his closing 61 is also the best final-round score in the history of one of golf’s oldest tournaments. Finally, with his win in 2019, McIlroy became only the sixth player to win the career Triple Crown, adding to his victories at the U.S. Open in 2011 and The Open Championship in 2014, joining Tommy Armour, Walter Hagen, Arnold Palmer, Lee Trevino and Tiger Woods in a coveted list.
So, with that, why not compare his current setup to the clubs he used to break all the records?
Driver
2019: TaylorMade M5 (9 degrees), Shaft: Mitsubishi Tensei CK Pro White 70 TX
2026: TaylorMade Qi4D (9 degrees @8), Shaft: Fujikura Ventus Black 7X (45 5/8 inches)

McIroy led the Tour in Strokes Gained: Off-the-Tee in 2019; he’s doing the same in 2026. Between now and then, McIlroy has switched from the Mitsubishi Tensei CK Pro White 70 TX (a shaft with slightly more feeling in the tip) to the original Fujikura Ventus Black 7X, having just made the change to the heavier version from playing the 60X.
What’s interesting about McIlroy’s 2019 setup is that the weighting on his driver is actually set in the high-draw setting, using the T-Track weighting system, whereas in the Qi4D, he’s currently using a heavily rear-weighted setup. (Two 13-gram weights in the rear and only two 4-gram front weights.)
The TaylorMade M5 driver he played in during his Canadian Open win was the company’s first head that they claimed to design to initially exceed the USGA’s COR limit, and then injected with tuning resin to bring it back in bounds.
Fairway woods
2019: TaylorMade M6 3-wood (15 degrees), Shaft: Mitsubishi Tensei CK Pro White 80 TX; TaylorMade M5 5-wood (19 degrees), Shaft: Mitsubishi Tensei CK Pro White 90 TX
2026: TaylorMade Qi4D 3-wood (15 degrees), Shaft: Fujikura Ventus Black 8X; TaylorMade Qi4D 5-wood (18 degrees), Shaft: Fujikura Ventus Black 9X

The TaylorMade M6 fairway wood that McIlroy was using during the 2019 season is still in the bag of some of the best golfers on Tour in 2026. Just check out Justin Rose’s winning setup from the Farmers Insurance Open earlier this year. This year, though, McIlroy has still been searching for his top-end-of-the-bag setup, having played both the new Qi4D and the Qi10, which he won the Masters with.

The same shaft swap can be seen in the fairway woods as the driver, along with slightly less loft on the 5-wood.
Irons
2019: TaylorMade P750 (4) Buy here, TaylorMade P730 (5-9), Shafts: Project X 7.0
2026: TaylorMade P760 (4), TaylorMade Rors Proto (5-9), Shafts: Project X 7.0

The biggest difference between McIlroy’s custom set and the stock P730s is the groove design. While the P730s were constructed with 14 MX-9 grooves on their milled faces, McIlroy’s proto heads instead use the higher-spinning, 16-groove layout of the TW2 grooves. Other big differences between the sets are that McIlroy’s 7- and 8-irons have thinner toplines, are 1 degree stronger in loft, and are 1/4 inch longer than the original P730 builds.
With McIlroy’s 4-iron, the switch from P750 to P760 sees a transition to a two-piece construction with Speed Foam in it, which allows McIlroy to launch the ball slightly higher, with more workability.
Wedges
2019: TaylorMade Milled Grind (48-09SB), TaylorMade MG Hi-Toe (52-09SB, 56-09SB, 60-LB09), Shafts: Project X Rifle 6.5
2026: TaylorMade MG5 (46-09SB, 50-09SB, 54-11SB, 60-08LB @61), Shafts: Project X 6.5 (46-54), Project X 6.5 Wedge (60)

Between 2019 and 2026, McIlroy’s focus on his short game has been much more apparent. It was the reason why he switched back to the TP5 golf ball, to help with launch, spin and control with his wedges leading up to his career Grand Slam victory in 2025. The most apparent changes to McIlroy’s wedge setup are his lofts and bounce. He’s slowly delofted his pitching to a sand wedge, but has increased the loft on the lob wedge, bending his current 60-degree to 61. With that, adding more loft to his lob wedge also slightly increases the bounce and leading-edge sit point, so, as a result, he plays a lower-bounce lob wedge compared to 2019. The MG5 wedges are also softer than the first Milled Grind option from 2019. McIlroy also no longer plays the full-face grooves found on the Hi-Toe.
Putter
2019: TaylorMade Spider X
2026: TaylorMade Spider Tour X

Notice anything similar. Yes, the copper finish on Rory McIlroy’s Spider X putter in 2019 is a slightly more reflective finish than the recently released torched PVD finish. McIlroy was using the True Path alignment system, but now uses only a single white sightline.
Ball
2019: 2019 TaylorMade TP5 (#22)
2026: 2025 TaylorMade TP5 (RORS)
As mentioned above, McIlroy had transitioned from the TP5 to TP5x golf ball since his victory in Canada in 2019, but now is black with the same style of golf ball as his victory at Hamilton Golf & Country Club.
Grips
2019: Golf Pride Tour Velvet Cord
2026: Golf Pride MCC
Interesting, McIlroy actually used Golf Pride’s Tour Velvet Cord grips during his victory in 2019 (it was during a 2+ year switch to the corded TV) as opposed to his usual MCC grips, which he has played for most of his career.
-
Equipment7 days agoMemorial Tournament Tour Report: Rory McIlroy, Cameron Young switch up drivers, and more
-
News2 weeks agoRussell Henley’s winning WITB: 2026 Charles Schwab Challenge
-
Equipment4 days agoBest irons 2026: Best irons overall, most forgiving irons, and more
-
Whats in the Bag4 days agoJ.T. Poston’s winning WITB: 2026 Memorial Tournament
-
Equipment1 week agoDetails on Jason Day’s latest prototype Avoda iron setup
-
Equipment3 weeks agoCJ Cup Byron Nelson Tour Report: Koepka and Kim’s newest putters finally get hot
-
News2 weeks agoCharles Schwab Challenge Tour Report: MacIntyre, Åberg and Spaun all switch putters, TaylorMade launches new Spider
-
Equipment2 weeks agoDetails on J.J. Spaun’s surprise putter switch

Bill
Nov 4, 2019 at 7:00 pm
I wouldn’t write off hybrids 100% yet. I dip into both worlds as I have a Mizuno MP H-4 bent to 22*. Shaft is X100 so probably around 130 grams. Love it. 215-225 window off the tee, 230 if I really lean on it. I also have an 18* Adams Idea Pro Black 9031 hybrid with a super stiff Aldila RIP alpha 105 gram shaft. I’m a pretty mid trajectory player most of the time and I can work both clubs pretty well. I hated hybrids for the longest time because I’d always hit this whippy snaphook that just hooked forever it seemed. The Aldila shaft solved all my problems so I guess the best thing for you to do would be to get on the range and hit everything you can. You could do a launch monitor obviously, but I’ve never really trusted them compared to the eye test. Also, the gap you are trying to fill is important as a hybrid or iron may just fit better there.