Connect with us

Opinion & Analysis

The Wedge Guy: Is there a single “secret” to a better short game?

Published

on

Last week, I asked for you all to send me your ideas for topics to address in my weekly blog and so many of you came through—we are off to a great start with this new “two-way” relationship I hope to have with you all. Thanks to those who wrote me. The topics presented so far covered a wide range of aspects of wedges and short-range performance, but one that was repeated in one way or another was whether or not I thought there was a single “secret” to building better wedge technique.

You know, I’ve seen so many great short games in my life, it’s often hard to single out one or two “secrets”, but I do think there are a number of core fundamentals that almost all good wedge players exhibit in their technique. Some of those are more obvious than others, but one that I find extremely enlightening for our “study” today is the way the hands and club move through the impact zone.

Take a close look at the photo I chose to illustrate this article and study it for a few minutes. You will see dozens of photos of tour players in this exact same position right after impact on a chip or pitch shot.

Now, let me tell you what I see from the perspective of an equipment (i.e. wedge) junkie who has studied the tools and the craft every which way from Sunday for over 30 years.

First, I see hands that have obviously been very quiet through impact as the angle formed by the forearms and shaft is identical to where it was at impact.


I also see that the hands are in front of the golfer’s sternum, which is likely where they were at address, into the backswing, and will continue to be for the rest of the follow-through. I am a firm believer that the less “hands-y” your wedge technique can be, the more consistent it will be. This golfer obviously is keeping his hands in front of his body through impact, so that the speed of his hands and therefore the club are controlled by the speed of his body core rotation.

I’m going to come back to that in a moment, but first…

Quiet hands also preserve the relationship of the sole of the wedge to the turf, so the impact “attitude” is a copy of the address attitude. In other words, the golfer has prevented a hinging and unhinging of the wrists that would likely cause the club to get more upright at impact, thereby compromising the turf interaction efficiency of the wedge’s sole design and bounce.

He has also preserved the loft of the club to that which he pre-set at address. For a low running pitch or chip, he might have added a little forward press and played the ball back a bit to keep it low. Or he might have played it a bit forward in his stance and set the shaft more vertical to add loft and spin to the shot.

But either way, his body core rotation totally controls the shot outcome, because he is not manipulating the clubhead through impact with his hands.

The point is, keeping the hands quiet and controlling the path, speed, and release of the club with the body core results in fewer moving parts and less room for error in contact, speed, and distance.

And back to that speed control aspect, I think the speed of the body core rotation through impact is more repeatable–for recreational players, weekend golfers, whatever you want to call us–than trying to memorize a number of backswing lengths to hit different distances.

But that is a topic for another post. For now–even if you are snowed in and can’t get to a range or course—take this picture and your wedge and go play around with it to see how close or far your own technique is to this tour professional. I think it will be fun.


And remember, as an advertiser on this page, Edison Golf is going to give away a free Edison Forged wedge every month to one of my GolfWRX readers chosen at random from all of you who send me an email with a question or topic for a future post. Just send to me at [email protected].

Thanks, and a repeated Happy New Year to you all!

 

 

Terry Koehler is a fourth generation Texan and a graduate of Texas A&M University. Over his 40-year career in the golf industry, he has created over 100 putter designs and dozens of wedges. In 2014, he put together the team that reintroduced the Ben Hogan brand to the golf equipment industry with his TK 15 wedges and Ft. Worth 15 iron designs. Since receiving a U.S. Patent for his “Koehler Sole” in the early 1990s, he has been challenging “conventional wisdom” in the wedge category. In addition to inspiring multiple companies to emulate this sole technology, the performance of his wedge designs have stimulated all other companies to reposition some mass toward the top of the blade in their wedges. Terry is retired from his role as Chairman and Director of Innovation for Edison Golf, and remains active in the industry as an independent designer and consultant.  But his most compelling work is in the wedge category. Since he first patented his “Koehler Sole” in the early 1990s, he has been challenging “conventional wisdom” reflected in ‘tour design’ wedges. The performance of his wedge designs have stimulated other companies to move slightly more mass toward the top of the blade in their wedges, but none approach the dramatic design of his Edison Forged wedges, which have been robotically proven to significantly raise the bar for wedge performance. Terry serves as Chairman and Director of Innovation for Edison Golf – check it out at www.EdisonWedges.com.

4 Comments

4 Comments

  1. Reid Thompson

    Jan 13, 2021 at 10:08 am

    Couldn’t agree more. When I keep butt of club aligned with belly button, even the bad contact is just low on head and spinny, and the good ones are good.

  2. Tom

    Jan 13, 2021 at 10:05 am

    Too much imagination from the writer, especially for a still shot.

    What I noticed is he removed his glove.

  3. Roy

    Jan 13, 2021 at 9:54 am

    Yes – use the bounce……

  4. gregory aziz

    Jan 13, 2021 at 9:46 am

    Terry
    Good points about the tools and the craft related to path, speed, and release.
    Perhaps this updated forum could demonstrate techniques via video conference using EDISON wedges.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Opinion & Analysis

AVL: My U.S. Amateur local qualifying experience

Published

on

This past Monday, I played in the U.S. Amateur local qualifier at Rock Creek Country Club in Portland, Oregon. A full tee sheet from 7:30 a.m. to 1:55 p.m., the top 11 scores would make it to the U.S. Amateur final qualifying.

I teed off at 10:48 a.m.. With the 7:30 am tee time, you can get a feel for the leaders’ pace, and they were off and running on the challenging setup at Rock Creek.

 

 

View this post on Instagram

 

A post shared by GolfWRX (@golfwrx)


Getting to the highlight of the round on the par five 17th, a drive up the left side and 212 yards left to the front hole location. I took out a 5-iron with plans of middle of the green. The ball ended up 8 feet left of the hole, pin high. A slight downhill putt dropped in for an eagle 3 on the 17th. With the cut line looking to be anywhere from -2 to even par. This was the boost I had been waiting for all day.

With making par from the trees on 18, it was time to wait for a potential playoff with a posted score of one under par 71.

Three hours later, it was playoff time. 8 players for 6 spots. I made par on the playoff hole, which was good enough to advance to the U.S. Amateur final qualifying in July. USGA qualifiers sure deliver on all of the emotions in golf!

Continue Reading

Club Junkie

Building my 2026 gamer WITB: Ranking the contenders and new putter projects – Club Junkie Podcast

Published

on

The annual What’s In The Bag build is underway, and on this episode of Club Junkie, Brian breaks down the clubs currently leading the race for a spot in his 2026 gamer setup. From drivers and fairway woods to irons, wedges, and shafts, he ranks the equipment that’s performing best and explains what’s separating the front runners from the rest of the field.

Brian also heads into the workshop to discuss several putter projects currently on the bench. From head options and shaft choices to build ideas and testing plans, he shares what he’s working on and which putters could become serious contenders for the bag this season.

If you’re a gear junkie who loves equipment testing, club building, and the never-ending pursuit of the perfect setup, this episode is for you.

Follow Club Junkie:
Instagram: @clubjunkiepod
TikTok: @clubjunkiepod
Threads: @clubjunkiepod
X: @ClubJunkiePod

Continue Reading

Club Junkie

Tour Edge Exotics mini driver review + TaylorMade Spider ZT Max first look – Club Junkie

Published

on

On this episode of Club Junkie, I put the new Tour Edge Exotics Mini Driver to the test and break down the performance, forgiveness, distance, and where it fits compared to a traditional driver or strong fairway wood. If you have been curious about adding a mini driver to the bag, this one is worth a look.

I also dive into the new TaylorMade Spider ZT Max putter that was recently spotted and discuss the growing zero torque putter trend. Plus, there is a closer look at the new Project X Titan Yellow shaft showing up on the PGA Tour and what makes it different from other profiles currently out there.

 

Continue Reading

Announcement

Our Privacy Policy and Terms of Use have been updated as of January 29th, 2026. Please review the updated policies here Privacy Policy | Terms of Use. By continuing to use our site after January 29th, 2026, you agree to the changes.

WITB

Facebook

Trending